Part Number GMLS4009

If you want to top off your vintage appearing LS swap then look no further than our distributor and plug wire set. We start with a set of high quality, 7 mm, Kevlar spiral core spark plug wires with high-temp silicone boots. The wires are 9’ long with 40 ohms of resistance per foot, giving you all the length and performance you need to remote mount your coils, out of sight and out of mind.

The plug wires first connect to the coils and then pass through the hollow cast aluminum distributor body that is bolted to the engine’s valley plate, and then on to the spark plugs for an authentic nostalgic look.

The LS Classic Distributor kit includes the plug wires with pre-installed 90 degree coil boots, straight unterminated spark plug boots (plug wire crimpers are needed to complete the installation), 90 degree distributor boots, distributor housing, cap, and terminals.

NOTE: Check firewall clearance to insure fit. Distributor is designed to bolt to the back two bolts of LS Classic valley plates (they will NOT clear valley plates with raised ribs or oil pressure sender boss).